Beijer-electronics SCOM Protocol EN Manuel d'utilisateur télécharger pdf (Page 98)

Command Reference

98 Beijer Electronics, MAEN975

6.56 LAU_CONTROL_DIGITALOUT (0x0203)

Digital Output Control

Sets the output pin state of the digital I/O port, if available.

Supported since Firmware Version

MT230 Nautic Monitor: 1.0

Command Stream

Response Message (Acknowledge)

Note:

On some devices, the output port bit 0 is internally wired to the buzzer. Setting this

bit will activate also the buzzer. In turn, enabling the buzzer with command

LAU_CONTROL_BUZZER will also set output port bit 0.

0 1 2 3 4 5 6 7...9 10

0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x02 0x03 Param ICHKD

Param

Value: Bit 0: 0: Clear output port bit 0 (disable buzzer)

1: Set output port bit 0 (enable buzzer)

Bit 1: 0: Clear output port bit 1

1: Set output port bit 1

Bit 2...7: unused

Type: Byte

Length: 1

Description: Digital I/O output port control

0 1 2 3 4 5 6 7...9 10

0x06 ADR

0x4C 0x41 0x55 0x03 ICHKH 0x02 0x03 Ret ICHKD

Ret

Value: Bit 0: 0: Output port bit 0 cleared (buzzer disabled)

1: Output port bit 0 set (buzzer enabled)

Bit 1: 0: Output port bit 1 cleared

1: Output port bit 1 set

Bit 2...7: unused

Type: Byte

Length: 1

Description: Digital I/O output port state

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 130 131

Pas de commentaire

Beijer-electronics SCOM Protocol EN Manuel d'utilisateur Page 98