Beijer-electronics iX Panel TA70 EN Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 45
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
Hardware Replacement
7.4 ReplacingtheDisplay/Display
Cable
The following is needed:
A new display including plastic frame and display cable, see
Available Spare Parts for iX Panel TA70
AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the s teps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Disconnect the two flex cables from the power card, according to the
illustration below, and remove the two plastic nuts that hold the power card
in place.
plastic nut
flex cables
plastic nut
4.
Lift the power card and gently remove the backlight cable from the rear side.
backlight cable
snap-in closure for plastic frame
guide pins
guide pins
5.
Gently loosen the complete plastic frame and display from the front plate.
Scrap the display and frame.
6.
Mount the new display/display cable and frame and re-assemble the complete
operator panel. Make sure the guide pins ontheframeareproperlyfastenedin
theholesinthefrontplate.
BeijerElectronics, MAEN012A
22
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Commentaires sur ces manuels

Pas de commentaire