Beijer-electronics T15BR EN Manuel d'utilisateur télécharger pdf (Page 10)

Installation

Connect the cables in the speciﬁed order, according to the drawing and steps

below.

Caution:

• The operator panel mustbe brought toambient temperature beforeitis started

up. Ifcondensation forms, ensure that the operator panelis d ry before connecting

it to the power outlet.

• Ensurethat the operatorpanel and thecontroller system havethe same electrical

grounding(reference voltage level),otherwise errors in communication may

occur.

• Ensure that the voltage and polarity of the power source iscorrect.

• Separatehigh voltage cablesfrom signal and supplycables.

• Shielded communication cablesare recomm ended.

24V DC

RS232/

RS422/

RS485

24V DC

Controller

Power

Ethernet

– Use 14–20 AWG (2.08–0.52 mm

ireforthepowerconnections.

– Connect cable A.

– Connect cable B, using an M

5 steel screw with zinc plating and a

grounding conductor (as

short as possible), that is sized correctly

according to local elec

trical codes.

– Connect cable C.

– Connect cable D.

Carefully remove the la

minated ﬁlm over the operator panel display, to avoid

static electricity

that could damage the panel.

2.2.1 ConnectionstotheController

For information about the cables to be used when connecting the operator panel to

the controller, please refer to the help ﬁle for the driver in question.

BeijerElectronics, MAEN165

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Beijer-electronics T15BR EN Manuel d'utilisateur Page 10