Beijer-electronics SCOM RBC EN Manuel d'utilisateur télécharger pdf (Page 13)

Command Reference

Beijer Electronics, MAEN993 13

5 Command Reference

The Lauer SCOM protocol exposes many commands for remote control of a Beijer

Electronics RBC by a dedicated software. It supports all standard SCOM commands,

as well as the new Lauer command set for special purpose functions.

This chapter describes each SCOM command and sub-commands for the currently

available device, Beijer Electronics RBC.

Although each Beijer Electronics RBC is based on the same base firmware and uses

the same communication, some commands/sub-commands are hardware dependant

and not supported for each device of the series, due to the differences within the de-

vice hardware. These differences and required firmware versions are indicated in de-

tail for each command description.

Note:

Response messages may be generated and sent back, even if the commands/sub com-

mands are not supported within a particular firmware version or if they are invalid.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Pas de commentaire

Beijer-electronics SCOM RBC EN Manuel d'utilisateur Page 13