Beijer-electronics iX T12C EN Manuel d'utilisateur télécharger pdf (Page 12)

Hardware Replacement

3.2 Replacingthe2.5”SATAMass

Storage

The following is needed:

• A new 2.5” SATA mass storage

• A T X10 Torx screwdriver

Note:

MakesuretouseadequateESDprotection.

Follow the steps below to replace the 2.5” SATA mass storage:

Power off the operator panel.

Remove the front frame assembly by removing the eight M3x8 Torx screws

on the b ack cover assembly.

Caution:

Duringdisassembly,itisimportanttotakecareofthecablebetweenthefrontandthe

rearpart. Ifyoudisconnecta cable,besurethattherightcablewillbeintheright

positionwhenassembling.

Note:

Theexchangeofelectroniccomponentsisonlyforexperiencedprofessionals.

Incorrecthandlingofelectroniccomponentsorcablespluggedinw rong,canleadto

thedestructionofthedevice.

Remove the four M3x4 Torx screws on the two hard drive brackets. Remove

thetwoharddrivebrackets.

Remove the two M3x6 Torx screws that are securing the brackets to the CPU

board.

BeijerElectronics, MAEN082D

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Pas de commentaire

Beijer-electronics iX T12C EN Manuel d'utilisateur Page 12