Beijer-electronics iX TxA EN Manuel d'utilisateur télécharger pdf (Page 12)

TxA Maintenance

3.2.5 Replac-

ing the Back Cover and/or CPU Card

The following is needed:

• A new back cover and/or CPU card

• A Torx T X10 screwdriver

Note:

MakesuretouseadequateESDprotection.

Information about spare par ts can be found in chapter Available Spare Parts.

Follow the steps below:

Power off the operator panel.

Remove the back cover (1) of the operator panel by removing the

Torx M3 screws (3).

Caution:

Opentheoperatorpanelslowly,takingcareoftheﬂexcablethatisconnectingthe

FrontUnittotheCPUcard(5)thatismountedinthebackcover(1).

Disconnect the d isplay cable according to the instructions in chapter Cables.

1. Back cover

2. Toothed washer

3. Torx M3 Screw

Beijer Electronics, MAEN021

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Beijer-electronics iX TxA EN Manuel d'utilisateur Page 12