Beijer-electronics iX TxA EN Manuel d'utilisateur télécharger pdf (Page 14)

TxA Maintenance

3.2.6 Replacing the Display/Display Cable

The following is needed:

• A new display— including front adapter board, display frame and a new

display cable

• A Torx T X10 screwdriver

• Phillips screwdriver

Note:

MakesuretouseadequateESDprotection.

Information about spare par ts can be found in chapter Available Spare Parts.

Follow the steps below:

Power off the operator panel.

Follow the instructions in chapter

ReplacingtheBackCoverand/orCPUCardto remove the back cover.

Unlock the ﬂex cable connector and disconnect the ﬂex cable from the

CPU b oard.

Note:

Theconnectormustbeunlockedonbothsidesbeforeremovingthecable.

Disconnect the LED ﬂex cable from the Front Adapter Board.

Beijer Electronics, MAEN021

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Beijer-electronics iX TxA EN Manuel d'utilisateur Page 14